Pro Clear Advantage Ultraviolet Clarifiers
Fitting the TMC Pro Clear Advantage unit could not be easier. The TMC Pro Clear Advantage is connected into the water circulation system as shown below and connected to a mains electricity supply in the same way as fitting a plug.
The TMC Pro Clear is designed to be positioned either on its base on a flat surface, or attached horizontally to a vertical surface using the brackets provided, and is supplied with dual inlet/outlet fittings allowing the unit to be fitted in the most convenient position available.
The TMC Pro Clear is supplied with dual inlet/outlet fittings allowing the unit to be fitted in the most convenient position available and universal hose tails are included to take 1", 11/4"and 11/2"flexible hose. No glueing is required. Full instructions are enclosed with each unit.
Easy to Use
Pro Clear Advantage units require virtually no maintenance and use unique translucent hose connectors which glow to show that the UV lamp is working.
Environmentally safe
Using ultraviolet light, TMC Pro Clear units destroy the green, single-celled water borne algae which make garden ponds murky and unattractive. As no chemicals are used, there is no danger of pollution or over treatment of the water and sensitive plant and pond life is not affected.
At the heart of each TMC Pro Clear Advantage unit is an ultraviolet lamp sealed inside a quartz sleeve. As water is pumped through the unit, ultraviolet light from the lamp destroys the algae, leaving the water clear.
Two sizes available
TMC Pro Clear Advantage UV30 which is suitable for ponds of up to 3,000 imp. gallons (13,500 litres) with a maximum flow rate of 3,000 imp. gallons (13,500 litres) per hour.
Pro Clear Advantage UV55 which is suitable for ponds of up to 5,000 imp. gallons (22,500 litres) with a maximum flow rate of 4,000 imp. gallons (18,000 litres) per hour.
CascadeBitz highly recommends calculating your uv requirements based on 10watts per 1000 gallons and under certain circumstances you may need to double this figure to 20w per 1000 gallons
TMC Pro Clear Advantage products are designed for reliability and a long working life. Spare parts and replacement lamps are always readily available.
Guarantees Clear Water
If installed in accordance with the manufacturer's instructions and the unit is the correct wattage for pond capacity, stock level and situation.
Product Information
• The TMC Pro Clear are manufactured and conform to BS EN 60598.
• The TMC Pro Clear conform to the low voltage directive (safety) CEE 73 23.
• The TMC Pro Clear Advantage conform to the EMC directive CEE 89 336.
• The TMC Pro Clear Advantage are CE approved.
Accessories & Spare Parts
All parts in our TMC Pro Clear Advantage units are individually replaceable and we supply a full range of spares including replacement UV lamps, quartz sleeves, hosetails and "O" Rings. |
